Initialising ...
Initialising ...
Initialising ...
Initialising ...
Initialising ...
Initialising ...
Initialising ...
Uwaba, Tomoyuki; ;
JNC TN9400 2000-006, 50 Pages, 1999/11
JNC-TN9400-2000-006.pdf:2.17MB
In the fast reactor the swelling of the fuel cladding occur due to the irradiation. Under the irradiation, the temperature gradient of the cladding through the direction of its thickness causes the swelling gradient and this will cause the secondary stress. In this study, we analyzed this secondary stress using the finite element model of the irradiation induced deformation of the cladding by FINAS code. The result of this analysis is summarized as follows. (1)The secondary stress is mainly caused by the gradient of the incubation period of the swelling, The secondary stress becomes very small at the end of irradiation due to the relieving of the stress by the irradiation creep deformation accelerated by the swelling. (2)The calculated maximum stress including the secondary stress under the irradiation is compared with the design value of the ultimate tensile strength for PNC316 for trial. The calculated value are lower than the design value. (3)The effect of the swelling accelerated by the stress is analyzed using the correlation between the swelling and the stress. The result shows that the increasing of the secondary stress due to the acceleration of the swelling is very small because the irradiation creep deformation relieves the stress more effectively by the acceleration of the irradiation creep rate due to the swelling.
Mizuta, Shunji; ;
JNC TN9400 99-082, 60 Pages, 1999/10
The density measurement of the internal creep specimens irradiated in FFTF/MOTA (Fast Flux Test Facility / Material open Test Assembly) was conducted MMF (Materia1 Monitoring Facility) and accurate separation of swelling strain from total strain leaded in the derivation of the irradiation creep coefficients. Irradiation creep coefficients for PNC 316, 15Cr-20Ni base S.S. and 14Cr-25Ni base S.S. were systematically expressed, while thermal creep coefficients K, under irradiation were separately expressed for above three steels. The results obtained are follows, (1)The effect of stress induced swelling was recognized in the temperature range from 405 to 605
C. The swelling in high stress specimens have a tendency to increasing swelling. (2)The irradiation creep coefficients derived from PNC316 and l5Cr-20Ni are similar to that of derived from 20%CW316S.S., CW316Ti and CW15-15Ti which were reported by other authors. (3)The irradiation creep coefficient derived from gas pressurized tube irradiation using FFTF/MOTA expressed appropriately irradiation creep strain from fuel pins using FFTF/MFA-2(15Cr-2ONi base S.S.).